Stuffing The Box - 5

Photos By Capt. Vincent Daniello

A spud-type stuffing box is threaded with one large nut that contains the packing.A spud-type stuffing box is threaded with one large nut that contains the packing. A gland-type stuffing box is smooth inside, and packing is compressed by tightening nuts on a pair of threaded studs (opposite). Start the packing by hand and use the insert to push it in. Tighten nuts evenly to keep the two faces roughly parallel. 

Tighten either spud, or gland-type stuffing boxes just beyond hand tight while out of the water, and lock the nuts together. Check the stuffing box in the water while still in the travel lift slings, but run the boat at cruise RPM for at least ten minutes before final tightening. Once back at the dock, Gaston likes to see at least one visible drip of water every ten seconds. With correct engine alignment and straight shafts, a stuffing box should drip steadily while underway and be at least perceivably damp after the boat sits overnight.

Most in-water emergencies can be solved by adding one ring of packing to the three worn rings already in the stuffing box. Be sure to repack it completely at the next scheduled haul-out. The water that comes in while adding that ring is disconcerting but manageable—especially if you know what to expect after repacking the stuffing box at least once in the boatyard.

Vetus Maxwell Tip of the Week

Hot Today

Featured Brands

Costa Palmos logo MCY logo
HMY Yacht Sales logo Volvo Penta logo
Absolute logo Sunseeker

Boat-Name Generator

cube puzzel Thinking of a unique name for your new boat can be tough, that's why we created a Boat Name Generator.
Try it here. ▶

Bonus: Follow these step-by-step instructions for servicing your stuffing box.

Select Brokerage