Sabre 48 Salon Express

Boat Tests


  • Sabre Yachts
  • Sabre 48 Salon Express
  • 2012
  • Down East
  • 1 master, 1 guest
  • 47'6"
  • 15'4"
  • 3'9"
  • 34,700 lbs. (dry)
  • 2/550-mhp Cummins MerCruiser Diesel QSC8.3-550s
  • none
  • 500 gal.
  • 160 gal.

Layout Diagram

Sabre 48 Salon Express layout diagram


SmartCraft DTS electronic controls w/ Cummins MerCruiser Diesel joystick
Kahlenberg air horn
Stazo custom steering wheel
Stidd helmseat (w/ UltraLeather upholstery)
Ritchie compass
Isotherm refrigerator
Seaward Gourmet two-burner cooktop
Tecma Eco MSD (master head)
ITT Jabsco Quiet Flush MSD (guest head)
St. Maarten reading lights
11.5kW Onan genset
2/Group 31 AGM batteries (engine start)
3/4D AGM batteries (house)
1/Group 27 AGM battery (genset)
20-amp. Xantrex Trucharge 2-battery charger
30-gal. Raritan water heater


OceanLED underwater lights
dealer-installed Garmin electronics package
entertainment package
Webasto electric sunroof
Freedom SW/3000 inverter
Glendinning CableMaster
dark-blue hull color
Freedom Dinghy Lift
teak decking in cockpit and swim platform


air temperature: 69ºF; humidity: 70%; seas: 6-8'; load: 380 gal. fuel, 150 gal. water, 3 persons, 800 lbs. gear.


380 gal. fuel, 150 gal. water, 3 persons, 800 lbs. gear.


2/550-mhp Cummins MerCruiser Diesel QSC8.3-550s

Zeus 3800 pods w/ 1.79:1 ratio

M7 propsets


The Numbers

Sabre 48 Salon Express - Final Boat Test Numbers:
rpm mph knots gph mpg nmpg range nm range db angle
1000 8.9 7.7 4.1 2.17 1.89 977 849 64 0.5
1250 10.2 8.8 7.9 1.28 1.12 578 503 65 2.0
1500 12.0 10.4 13.3 0.90 0.78 406 353 67 3.0
1750 15.3 13.3 22.1 0.69 0.60 312 271 72 3.5
2000 20.2 17.5 28.3 0.71 0.62 320 279 72 3.5
2250 25.1 21.8 34.1 0.74 0.64 331 288 74 3.0
2500 28.6 24.9 42.4 0.67 0.59 304 264 75 3.0
2900 34.0 29.5 59.5 0.57 0.50 257 223 76 2.0
  Speeds are two-way averages measured w/ Stalker radar gun.
GPH taken via SmartCraft display.
Range is 90% of advertised fuel capacity.
Decibels measured at helm on A scale. 65 dB-A is the level of normal conversation.


OceanLED underwater lights
dealer-installed Garmin electronics package
entertainment package
Webasto electric sunroof
Freedom SW/3000 inverter
Glendinning CableMaster
dark-blue hull color
Freedom Dinghy Lift
teak decking in cockpit and swim platform

Photos by Billy Black

New England Sleigh Ride

We ran this beauty hard, from Portland to Rockland, Maine, and she never faltered.

The old Custom House Wharf in Portland, Maine, had a raw, commercial-seafaring quality to it that morning. The buildings on either side were ancient, clapboard-sided, and scruffy. The wind whooping off Casco Bay was salty and brisk, especially for mid-August. And the passersby were locals, not tourists.

“Better get a big breakfast,” I told PMY senior editor Jason Wood as we entered the Porthole Restaurant, “Lunch is a long way off, buddy. Gonna be one rough ride headin’ up to Rockland.”

We ordered eggs Benedict with lobster, as I recall. And while downloading this delightful repast, we reviewed the day’s duties. First, we had to safely deliver a brand-new Sabre 48 Salon Express from her temporary lodgings nearby to a berth at the Maine Boats, Homes & Harbors Show in Rockland, some 75 NM north. And just as important, we had to collect test data along the way.

This last deal was gonna be challenging, most likely. The weather report featured foggy rain, 20 to 25 knots of wind, and four- to six-footers coming out of the east. There were a couple of nice little islands in the Rockland area, however, and we figured at least one of them would offer enough protected, semi-smooth, radar-gun-friendly water to get the job done.

Sabre marketing v.p. Bentley Collins was already onboard the 48 when Wood and I showed up with our sea bags and test equipment. An Australian by birth, French Canadian by happenstance, and American by choice, Collins shot a weather eye aloft and observed with a grin, “Perfect day for a real test, eh boys?”

The sheer size and muscularity of the 48 proved as invigorating as Collins’ up-and-at-’em attitude. Her superstructure, topped off with a beefy but stylish sedan-type hardtop, was fully integrated into her rail-encompassed weather deck. Indeed, I detected nary a seam or joint that might work open or give underway and invite water intrusion. Her bow was gracefully elevated and flared, a design feature that promised a relatively dry ride. And the three windshield panels just beyond her helm station were large, robustly ensconced in thick fiberglass mullions, and accoutered with big, businesslike wiper blades.

Of course, most boat deliveries are time-sensitive. So with a nod to the necessity of making a mile, I jumped aboard, went forward, and fired up the 48’s powerplant, a matched set of 550-mhp Cummins MerCruiser QSC8.3-550 diesels with Zeus 3800 pod drives. By the time I’d finished making sure both the SmartCraft  Digital Throttle & Shift (DTS) binnacle control and the Cummins MerCruiser joystick were working smartly, Collins and Wood were poised to cast off. “Let ’er go,” I yelled and poured on the coal.

Casco Bay was freakin’ outrageous when we got there. And when I set a northerly course for our destination, with the rollers hammering the starboard bow like blazes, it became even more so. I continued to gently accelerate though, and soon we were sporting along at roughly 20 knots (according to one of the two Garmin GPSMap 7215 screens on the dash) with the promontories of the Pine Tree State to port and the gray vastness of the Atlantic to starboard.

What a ride! The little world around our 48 was purest mayhem, no doubt about it. But tracking stayed straight, despite our more-or-less sideways orientation to the craziness. Moreover, visibility from the Stidd helm seat I sat cross-legged in was excellent, even when I occasionally pulled back on the sticks to raise the boat’s nose and soften an especially menacing impact. And the vessel’s agility—her rapid response to even slight movements of the steering wheel—made driving a pleasure.

Sabre’s head designer Kevin Burns was at the bottom of all this performance, apparently. In order to maximize onboard interior space, Collins said, Burns had decided to put the 48’s propulsion machinery as far aft as possible, a move that meant her mains were close-coupled to their respective drives and not extensively jackshafted. Several prospective customers had been leery of this approach, Collins noted, fearing it might put the longitudinal center of gravity too far aft, thereby causing overly high running attitudes, visibility issues coming out of the hole, and lackluster performance.

“But Kevin worked a bit of magic with this boat,” affirmed Collins. “He used wedges in her tunnels to give a slight down-angle to the Zeus units, a new, proprietary buttock-line arrangement, and some clever swim-platform hydrodynamics, all to keep the running attitudes at approximately three degrees throughout the planing range.”

We leapt a particularly deep chasm, and I wondered aloud whether credit for the stout New England sleigh ride we were enjoying might also go to construction methods and materials. “Oh my yes,” replied Collins. “All the major parts are made of resin-infused biaxial E-glass with one type of coring material or another. We even co-infuse the stringers and the hull simultaneously. That’s why we’re seeing all this rigidity and resistance to twist.”

Life’s funny sometimes. Back in Portland, Wood and I’d been worried about the roughness of the ride we’d experience traveling up the coast. But when we finally arrived in Rockland that afternoon, our concerns had nicely transitioned into confidence. And as we collected test data in the lee of a rocky shore, confidence transitioned into enthusiasm—for a rousing top speed of 34 mph, church-mouse sound levels, and a set of superb running attitudes. Who knew that our impending boat-show docking would be the real hell-raiser of the day?

“Change of plans,” yelled Collins from the bow. “Just spin ’er about in here and put ’er over there behind that red sailboat.”

I looked around. Things were slightly more complicated than Collins was indicating. First off, our arrival at the show had been late. So I’d been constrained to box the 48 into a tiny spot, one literally surrounded by spectacular (and spectacularly expensive) vessels, all tied up at this point and all overrun with potential witnesses. And the room I needed to “spin ’er around,” as Collins breezily put it, did not seem to be there, and neither did the room I needed to squeeze the 48 in behind the museum-quality sloop.

Zeus to the rescue, I gotta say!

With an assist from our Cummins MerCruiser joystick and a raft of directives from Collins like “Go ahead three inches. Stop!” I was able to safely rotate the 48 and sidle her into the appropriate berth, with her bow overhanging the sloop’s transom by three feet.


Immediately afterwards, Collins gave a brief tour of the 48’s bright, Epifanes-varnished, two-stateroom-two-head interior. It’s a grand place and Collins was obviously excited showing it off. So as luck would have it, I think he totally missed the several sighs of relief I breathed during the proceedings. And gratefully, Wood seemed to miss ’em too.

Sabre Yachts
(207) 655-3831.

This article originally appeared in the February 2012 issue of Power & Motoryacht magazine.

Vetus Maxwell Tip of the Week

Hot Today

Featured Brands

Costa Palmos logo MCY logo
HMY Yacht Sales logo Volvo Penta logo
Absolute logo Sunseeker

Boat-Name Generator

cube puzzel Thinking of a unique name for your new boat can be tough, that's why we created a Boat Name Generator.
Try it here. ▶

Select Brokerage