More to Come Page 3

Electronics — December 2003
By Ben Ellison

More to Come
Electronics Q&A
 More of this Feature
• Part 1: Raymarine
• Part 2: Raymarine
• Electronics Q&A
• Telesea
• Standard Horizon
• Nobeltec
• Interphase
• Sailor’s Solutions

 Related Resources
• Electronics Column Index
• Electronics Feature Index

My GPS loses its signal whenever I run my radar. It’s mounted about three feet behind the open-array radar antenna on the flying-bridge hardtop. I raised it on a two-foot extension to no avail. D.D., via e-mail

The NMEA Installation Standard states that GPS antennas “shall not be installed in the direct beam of a radar antenna.” That beam is generally specified as 25 degrees vertically—12 1/2 degrees below the horizon, 12 1/2 degrees above—so your newly raised antenna should be working. However, the beam edge is also defined as where the radar signal is less than half of its nominal strength; apparently even a small percentage of your fairly powerful radar is able to smother your GPS antenna from a few feet away. Try moving it again, and bear in mind that since it is trying to hear signals from the sky, not from over the horizon, it will likely be quite content down on the side of your flying bridge or even on your trunk cabin top, lower but well away from your other antennas. That’s why most current GPS antennas can be alternatively mounted directly, and with low profile, onto a horizontal surface. But I’ve also heard of boaters who’ve drilled a hole in a metal pie plate and stuck it under a mast-mounted GPS antenna to protect it from the sort of low-angle interference you are experiencing—though it strikes me as a stubborn approach!

The whole business of interference between various active and passive marine electronics is complicated. For instance, GPS satellite signals are so weak that they can get messed up by nearby VHF, SSB, satcom, and even cellphone transmissions. It’s not for nothing that the NMEA Standard has both a table of suggested minimum horizontal spacing for all antennas and a rigorous protocol for testing each new installation for interference to or from each existing installation. —B.E.

Got a marine electronics question? Write to Electronics Q&A, Power & Motoryacht, 260 Madison Ave., 8th Fl., New York, NY 10016. Fax: (917) 256-2282. e-mail: No phone calls please.

Next page > Telesea > Page 1, 2, 3, 4, 5, 6, 7, 8, 9

This article originally appeared in the November 2003 issue of Power & Motoryacht magazine.

Vetus Maxwell Tip of the Week

Hot Today

Featured Brands

Costa Palmos logo MCY logo
HMY Yacht Sales logo Volvo Penta logo
Absolute logo Sunseeker

Boat-Name Generator

cube puzzel Thinking of a unique name for your new boat can be tough, that's why we created a Boat Name Generator.
Try it here. ▶

Select Brokerage