After the Fall Page 3


Shrink-wrapping involves covering the boat with a plastic film that is strapped in place and then shrunk with a propane heater. You can have your yard or a shrink-wrap firm do the job for you or do it yourself with a shrink-wrap kit that's available at most marine stores and contains the film, propane heater, and even a how-to video. Often, several boaters will buy one kit and extra film to reduce costs.

Before shrink-wrapping begins, you'll need to pad all sharp corners with some carpet scraps or foam. Lower all folding antennas, and place a length of PVC pipe over them to prevent the shrink-wrap film from bonding to them.

Large cockpits or other open areas may require a support to prevent low spots where snow, ice, and water can accumulate. You'll also need to add a few vents after the wrap is in place to prevent mildew and condensation. Finally, you can add a zippered door if you want access to the boat's interior.

This article originally appeared in the September 2006 issue of Power & Motoryacht magazine.

Vetus Maxwell Tip of the Week

Hot Today

Featured Brands

Cutwater MCY logo
HMY Yacht Sales logo Ocean Alexander logo
Imtra logo Volvo Penta logo

Select Brokerage

Brokerage Listings Powered by