Boat test for the 2006 Baia Azzurra 63 including boat specifications, photo galleries, boat videos, boat layout diagrams, boat test numbers, boat test results, and boat speed graphs. Also includes pricing, engine test reviews, ratings, standard features, and gear for the 2006 Baia Azzurra 63.

I am a voracious reader, but occasionally I find it tricky to decipher the meaning behind certain works. In his book Mother Night, Kurt Vonnegut made it easy for me: He states the novel’s theme in the preface. “You are what you pretend to be,” Vonnegut writes, adding that we should be darn careful about what we pretend to be, as we may just become that. Recently I was at Allied Richard Bertram’s Fort Lauderdale, Florida, office for a wring-out of baia’s 63-foot Azzurra, and a below-decks inspection had me thinking of Vonnegut’s statement. Had baia turned its back on its racing heritage in favor of luxury and comfort?

Her saloon is huge and luxurious, with 6’8” headroom and a plush, L-shape, red leather settee to starboard. Across from here, her granite-topped galley’s full-size Whirlpool refrigerator/freezer and abundant stowage could easily swallow a week’s worth of cruising provisions for a family of four. Two aft staterooms, each with a set of single berths, complement a forepeak master with walkaround queen. In addition, en suite heads with showers serve all staterooms.

Looking around this well-appointed interior, I began to wonder. Cantieri de Baia made a name for itself over the last 20 years on the European racing circuit for its exclusive use of surface-piercing drives and pre-impregnated Kevlar hulls, not cushy accommodations. Had baia gone soft?

Not by a long shot. My test boat reached an average top speed of 54.4 mph, darn respectable for a 63-footer, especially when you consider we were in the open ocean, bouncing over steady three- and four footers. Attribute her speed partly to a relatively lightweight Kevlar composite hull: At 55,000 pounds, the 63 is approximately 10,000 pounds lighter than a competitor’s similar-sized and-powered express. But some of the credit also goes to her optional 1,502-hp MTU 10V 2000 M93 common-rail diesels and standard Arneson ASD12 surface drives.

Piloting the 63 was markedly different from running shaft-driven counterparts. “It’s a technical boat to run,” commented Allied Richard Bertram’s Capt. William Walker, who joined me on the sea trial. I watched closely as he provided a tutorial.

To get the 63 up on plane, he trimmed the Arnesons all the way up using joysticks grouped on the helm along with sticks for the bow thruster, tiller, and trim tabs. Next he firewalled the MTUs: With half of the big Rolla props (Twin Disc, which owns Rolla, declined to release the prop size) out of the water, there wasn’t much bite, and the 63 crawled forward. Once the MTUs reached about 1200 rpm, Walker slowly dropped the drives. At 1500 rpm the props, now fully submerged, got a good bite, and as Walker yelled, “Here we go!” and as the MTUs went from 1500 to 1750 rpm, our speed doubled to about 39 mph. Walker then raised the drives, reducing drag and bringing the blades half of the water, which produced a roostertail a few boat lengths off our stern: Just like that my Stalker radar gun read 56.4 mph before conditions dictated that Walker throttle back to a cruising speed of 48.5 mph at 2000 rpm.

PAGES:

1

2